-
Error E04-0293
I just had to replace my QC Chuck and upon replacing it the machine began to scan the board for the project that is 14 5/8" Wide. While measuring the length of the board which is 67" it began to stutter back and forth rapidally until I pressed Stop and it displayed Error E04-0293. I should also say that while tighteningthe piece down the racheting capability seems to have been lost? Any Ideas what is going on? Please help!!!
I should say that the QC Chuck broke on this board just under a week ago so it has scanned and ran before!?!
Last edited by waynedazey; 06-03-2011 at 11:11 PM.
Reason: additional information
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules