Post what you started with.
I think all you have to do is uncheck floor feather and set feather to zero. Maybe others have additional suggestions.
The box was because of the white background of the graphic. I removed the background. I do not know what size you were going for. See if you can work with this:
If this is what you are looking for:
I used Photoshop to remove the white background and clean up the color. I also changed all parts of the "Q" to the same color so they will carve at the same depth.
1. Import the image
2. Drag pattern onto a 28" by 4" board
3. Remove the feather
4. Set merge to subtract
5. Set Bit Optimization to Best
6. Set depth to .35"
This will work in version 1.187 also.
EDIT: It looks like Bergerud and I were responding at about the same time.
Last edited by SteveNelson46; 05-14-2016 at 10:48 PM. Reason: Comment
Steve
You guys are fantastic. Many. many thanks.
Stan Schmidt
Woodwork By Stan
Elk River, MN
They sure are the best .... I luv the way the troops circle to help ... I'm terrible with patterns and such, so I need the community, they have never failed me ..
Mans Quest for knowledge,,, means he'll always find a way !!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!