I'm doing a project that calls for a board 14" long, 1.75 wide, and .5 thick. When the carvewright cut the board it cut it 12 3/4 long. I have double checked the layout and it's fine. Any ideas?
Sensei
I'm doing a project that calls for a board 14" long, 1.75 wide, and .5 thick. When the carvewright cut the board it cut it 12 3/4 long. I have double checked the layout and it's fine. Any ideas?
Sensei
The board could have....
1. Asked you to scale the project after measurement and you said yes.
2. Board popped up and the brass roller was not making contact causing a length error.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Right on the button Al. It Asked me to scale the project after measurement and you said yes. I'm bad.
Thanks Al