I still can't break loose the QC Chuck using a heat gun. I have been advised that I will have to eat the QC body to red hot in order to break loose to Loc Tite. My fear is transmitting too much to the bearings. I can baffle the heat from all surrounding parts to protect from heat but am hesitant to apply that much heat with suggested propane torch. Any good suggestions would be greatly appreciated. My QC failed in my first 2 hours of operation. I think the QC is a poor design as when I observed the parts that flew out
they looked to be defective from day one. Hopefully CW will make a change or the aftermarket suppliers will!

Joesow