Seems I have a couple of problems that I think may be major and don't think I should carve until I get these resolved.
I got my machine back a few weeks ago (3 weeks with no carves) and immediately had a problem. Then I had to move on to a couple of other deadline jobs that had to be finished and so lost another week. Now - The the board will not measure the length when I begin a project, but will measure when I do a manual (7) and then length. I can then start the carve. I have not let one finish, because I was noticing a couple other things. So I called Hardware support who told me that they are the same operation and it was very curious why it would do that. The support guy took down all the info and said he would talk to his supervisor (who has never called). We also checked the roller pressure, that was good. But now I cannot get a "click" when I lower the head so I have no idea if the pressure is correct.
They sent me a rubber washer that they believed would fix the problem. It didn't. (another 2 weeks with no carves). Again - deadline projects so I could not carve, but was waiting for the callback so was Ok waitting for a little while.
I need to get some carving done. Any suggestions out there?