hi
is me 1 scan for probe in quality best
1:04 time
very good
hi
is me 1 scan for probe in quality best
1:04 time
very good
Last edited by gcioffi; 05-25-2008 at 04:01 PM.
Excellent scan! You are doing great with the scanning probe! Thank you for sharing!
Audie
CarveWright - 192 days and still not able to carve
gcioffi
Thats a wondeerful looking scan, however I got a warning when I downloaded it about the depth of carve. I see your useing cm as I am useing inches.
Does anyone know off hand how deep this carving is ? It's 2032 cm but whats that in inches.
OK I think I figured it out. My screen is small enough and lettering so small I couldn't tell if the depth measurement 2032 or what. I figured out it must be 2.032 cm which converts to 0.800 inches.
Carvers beware though I did get a warning about the depth of carve on this one. That is the max the machine will carve,which is pretty deep.
later Daniel
Last edited by Dan-Woodman; 05-26-2008 at 07:04 PM.
1.187 Custom Woodworking for more than 40-years
is the height is 2 cm
I do not understand the max height of cut is 2 cm.
I imported as original, now you changed your pleasure
The maximum length the carving bit will cut down into the wood is .800 inches which is 2cm.
The total length of cut the machine is capable of is 1.00 inches.
When you upload your project to the memory card , watch for error codes.
Some carvers may dispute this depth of cut issue.
The spiral cut on my carving bit is longer than .800 , but the sharpened area of the bit is .800 If your carving deeper than that , your just pushing the wood out of the way ,not slicing it with a sharp bit.
later Daniel
1.187 Custom Woodworking for more than 40-years
thanks
you are right I happened error for the memory card
I lowered to 0.65 "now is ok.