Michael did a GREAT JOB on the Manual Cut Path's on the May Tips and Tricks. So many GREAT things we have learned.
Thanks Michael,
AL
Michael did a GREAT JOB on the Manual Cut Path's on the May Tips and Tricks. So many GREAT things we have learned.
Thanks Michael,
AL
Yes that was a very good article.
Speaking of cutpaths, in case anyone didn't know this like me If you have a carve region on the back of a carve that extends to the edge where the cutout would be on the front, thus making the board thinner in that area, apparently the software compensates for this and leaves tabs at the appropriate level instead of at the bottom of the board.
Ver 1.150
Kevin
"Carving has it ups & downs"
Kevin,
Thanks for the heads-up!
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi