Sled/jig
Crogers,
What size is the sled and how is it constructed? With a 4" X 6" board (I'm assuming that is the size in Designer also), your sled needs to be 7" longer than the carved portion (or board) and about 1.5" wider.
You would need side rails that are the same height as the board-surface and the length of the jig.
You need filler pieces on the ends or tape across the ends for the sensor to read the length.
Then tell it NOT to stay under the rollers and to center on length.
There are other options but this is the simplist that I have found other than simply using Rails without a Carrier-board (with the same dimensions and commands).
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi