i got my machine two day ago on my fist try to test cut the board, it running for about 30 second the screw holding the guide baring from an z axes fell out. LO (WTF) after i screw the baring back on open the cover and checking all the screw found three more screw it loose. i think machine was make monday morning by some dude still got a hang over.. back on testing i try to cut feed the the board on the second try every thing seem to work ok. my fifth test i try to check for repeat loop test, the X axes some how stall keep go back and forth, and it increase the back and forth motion for about 20 second and the traction belt broke OMG. i call carvewright to buy the tractiong bell they say they not sell to canadian, (WTF) poor me my canadian dollar is no good. i ask them is sear selling accesories for this machine. they said no. the only place i could get a replacement accesorie is from carvewright, Dam now i am my own. is any one know who sell the traction belt in bellingham WA. ??