Hi All,
I have just started looking into the Carvewright machine and it seems to do a lot more than I thought it would and have downloaded the demo software and seems fairly easy at first, I have a cnc mill for metal already and know that the software is only for use wih the Carvewright , but if I find a used carvewright do I have to pay for the software? Or is it registered to the machine and I get new registration codes when I buy a used mill..
Also in the design page can you design a part larger than 14.5 inches then split them to cut in 2 diffent peices? I know it will cut as long of a part as I want but wondering about width..
Ok thanks for the help and by looking around the board there are a lot of people who like this machine and willing to help with any information needed ..
Thanks in advance ..
GaryV..