Luv2smellnitro
If it were me , I 'd stick to the scrollsaw for this one . If you use the states patterns here or anyone for that matter , you will have to resize them,and hope they all fit together once there cutout.
Like Terry said too, router bits leave round corners on inside cuts.
Another possibility though, you could have one project of all the states together , and just have the cw outline each state with a v-bit. This would make a great "quarter"state collecter board. Seems like I might have seen one of these on here somewhere also.
On anouther subject, is your user name referring to top fuel and funny car nitro? Yea!!! 2008 starts this weekend.
later Daniel
Last edited by Dan-Woodman; 02-09-2008 at 03:47 PM.
1.187 Custom Woodworking for more than 40-years