I am tring my first scan and I have notice that the probe is scoring the object I am scanning, is this suppose to happen.
I viewed the video and it did't seem to touch the object.
Little help would be great.
I am tring my first scan and I have notice that the probe is scoring the object I am scanning, is this suppose to happen.
I viewed the video and it did't seem to touch the object.
Little help would be great.
myshop1044,
The probe tip dose make contact with the object being scanned
and may damage it's surface. There are some posts and threads on the subject.
This is one I found
Softer Scanning probe possibility
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Thanks for the info, I looked at the scan after it finished and it looked ok
for now I will try carve it later
thanks again.
My probe for the shopsabre has a slight bit of rubber or plastic on the tip.I have read on the forum here where guys were using tip of super glue and other things to make a softer point so as not to scratch delicate items.
Ben