The main reason I began looking into the CW was to have small molding reproduced for antique furniture and old homes. Is there anyone out there that has reproduced old molding????? Please advise.
The main reason I began looking into the CW was to have small molding reproduced for antique furniture and old homes. Is there anyone out there that has reproduced old molding????? Please advise.
Hello refinisher,
I've not done that personally, but I know a couple simple ways how to...
1) Take out a section of the original moulding and scan it with the scanning probe to make a pattern
2) Make a mold of the original, make a cast of the moulding, then scan the casting to make a pattern
Does this help?
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
and don't forget to purchase the probe first, alone with the cw.
1.187 Custom Woodworking for more than 40-years
Take a look at these posts and thread, both are about the same possess. Casting profiles for scanning??
Last edited by Kenm810; 12-12-2007 at 06:19 PM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails