When you install a new bit into an adapter. I know that you loctite the screws but what I am wondering is if the set screws should protrude the same distsnce from the adapter after they are tightened?
When you install a new bit into an adapter. I know that you loctite the screws but what I am wondering is if the set screws should protrude the same distsnce from the adapter after they are tightened?
Gimme Steam.
If your talking about the same distance on each side , I would say yes. If one is sticking out farther than the other ,then one must not be screwed in as far as the other.
1.187 Custom Woodworking for more than 40-years
It depends on wether there is a flat spot on both sides of the bit. Some only have one. That will make it stick out further.
If You Saw What We Sawed!!
North Bay Woodworking
If you don't want to make waves......get off of the boat!