All right fellas, see if anyone has a resolution to this. I'm having a z-axis stall, error 246. I'm unable to get my machine to start cutting at all. What happens is the machine reads my program, goes through the measurement of the board, and then finally starts homing the bit. But every time it goes to find the surface of the wood (z-axis), the bit just sticks into the wood and gives me the error message.
I've tried different patterns, different thicknesses of wood. I've also calibrated the machine with the jointing bit. Also, I've even tried updating the firmware to 1.20 and installed the software on Vista and a computer with XP. Any advice? I'm reading a little about a z-motor, but I'm not sure what's involved there.
Thanks for all your help.