Hello All,
I called Tech Support on Sat. but no answer so I left a message with no response. I searched the forum and no luck. So here's the problem: I wrote a simple program for a threshold for my kitchen, which I set it up selecting the 1/4" ballnose as the pattern bit. I loaded the machine, started the project, measured the board and it then asked me for a 1/16" carving bit. I turned the machine off checked the program, good, checked firmware version, 1.12, reloaded the program and same results, "Load 1/16" Carving Bit". Any help or suggestions would be 'muchly' appreciated.?
Thanks,
Rick