Thought I would try some carving with corian . Have to say that I’m very happy with the out come. They were carved on.25 inch with a depth of 0.150 and the height was set at 400.
Light shining though the back. " Lithophane "
Thought I would try some carving with corian . Have to say that I’m very happy with the out come. They were carved on.25 inch with a depth of 0.150 and the height was set at 400.
Light shining though the back. " Lithophane "
Last edited by Matty; 06-30-2007 at 12:22 AM.
Matty,
Very nice carvings, did you have do anything special to the photos before carving them.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Very, very nice. Can you detail how you took the photograph and got it ready for carving? What programs and settings?
Thanks,
Don
Hi Matty; Your Carving Is Beautiful And I Have To Ask- This May Sound Like A Stupid Question Butt, Did You Do It On The Compucarve? And If So, With What Bit Did You Use? Please Do Tell Us Your Process. Thanks
Thanks for the comments everyone.
JOHNB there are no stupid questions.. except when I asked my 2nd wife to marry me.
Yes it was carved on the Compucarve, I will have a detailed How to in a few minites so check back
Matty
Here is a step by step .
Not: when you carve the image it needs to carve inverted . Yo can down load the mpc file below to see what I mean
http://www.idealmarking.com/carve/test1.zip
NOTE: I used Photoshop to prepare the images you can yuse any othe graphic programe Corel draw ect.
Matty
Last edited by Matty; 06-30-2007 at 11:19 AM.
Very nice Matty
Dennis
Matty,
Beautiful work, and great explanation. Thanks for sharing both.
Don
How long did it take once you hit the "go" button?
Azbear, It toolk less than 1 min to convert the image,
Carving 1.27 hrs on best setting
Matty