power fluctuation error

[oldjoe]

I have just gotten back into using my carver I was able to get the computer issues resolved but stated a carve everything went fine. Bits measured okay board measured fine. Started to carve and it stopped . Messages said " Power fluctuation press enter to proceed ," I do that it carves for a little bit and quits again, sometimes it makes a full pass before shutting off,

[want2b]

Have had this problem with my original A machine, problem is in the power supply. Not sure how deep you are willing to go but the fix involves opening it up and doing some inspection of solder joints and then resoldering of a connection. Link posted will give you a lot of info. If it doesn't give you enough try an advanced search for 'power fluctuation' and you'll get a lot of posts that apply.
https://forum.carvewright.com/showth...er+fluctuation

Good luck