Hello,


I am building my first 3D printer and am working on a challenge. I am testing my stepper motors and while I can get them to move correctly, I cannot get them to move fast or they jam. If I move the motors faster than 1500mm/min in octoprint they stop moving and make a horrible noise. The motors spin freely but I have not loaded them yet.


My printer is a CoreXY model and I have only connected the x and y motors to my RAMPS 1.4 board. I am using a DM542T driver (https://www.oyostepper.com/goods-111...per-Motor.html) So far I have only connected the driver to the x and y axis. The units are set to 1/16 microstepping. The power comes from a PC power supply, I only connected 12V to the 5A port of the RAMPS.


My stepper motor is a 23HS22-2804S1 (https://www.oyostepper.com/goods-74-...6mm-Shaft.html)


Am I doing something wrong or these motors can't spin faster?