craving pocket region

[TOOLMAN7353]

When craving say a 6" square pocket region 1/2" deep, how do I leave a 2" square cube in the center of the crave? I should know the answer but I don't.

[want2b]

Probably different ways but I would create the 6" carve region 1/2 " deep, center both ways. Then create a second carve region in the center 2" with a depth of .001 and center both ways. Should give you the uncarved block in the center. Hope this is what you're looking for, if not let us know.

[TOOLMAN7353]

Probably different ways but I would create the 6" carve region 1/2 " deep, center both ways. Then create a second carve region in the center 2" with a depth of .001 and center both ways. Should give you the uncarved block in the center. Hope this is what you're looking for, if not let us know.

Thank you. I'll give it a try.