Page 1 of 2 12 LastLast
Results 1 to 10 of 20

Thread: 18 pin cable

  1. #1

    Default 18 pin cable

    Hi
    I have the original Craftsman Compucarve A series CNC.
    I had it in storage for several years. I decided to get it out, clean it up, and get it going again.
    Unfortunately I found that the 18 pin cable ribbon to the spindle head was damaged by a rat.
    I called Carvewright to get another one but I was told that the ribbon was discontinued since 2007 and I would have to upgrade my CNC to get the 14 pin ribbon. That would cost hundreds of dollars.
    I can’t afford a new machine, so I’m hoping to get one from someone who upgraded their machine.
    I sure appreciate it.

  2. #2
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,984

    Default

    Sorry to hear about your 18 pin cable. Due to it's thinness it would let conductors snap inside the plastic leading to many problems from the bit driving into the board and jamming, Air Carves, Board Sensor reading errors. I will post your request on the CarveWright facebook page as it gets allot of attention. Ask them to come here and contact you.
    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


  3. #3

    Default

    Thank you! I need all the help.

  4. #4

    Default

    A cable may be available through electronics suppliers. Please measure the exact length and width of the cable, and if possible the spacing between conductors (will likely be in metric). Also a close-up photo of one end showing the conductors. I buy electronics regularly and may be able to find a supplier for you.

  5. #5

    Default

    Thank you. I am a little slow right now I appear to have a little stoke.

  6. #6

    Default

    The cable is 23 long and 3/4”. It has 18 points at the end.

  7. #7

    Default

    Are the contacts on the same side of the cable, or opposite sides?

  8. #8

    Default 18

    I canít put pictures in it, but it has blue in it, no end.

  9. #9

    Default

    It has same end. Send picture of what you got .

  10. #10

    Default

    What I am asking is the cable a "Type A" or "Type B" per the attached photo.

    Click image for larger version. 

Name:	cable type.PNG 
Views:	9 
Size:	31.4 KB 
ID:	88660

    We also need to know the pitch of the contacts. If the cable is 3/4" wide, with 18 contacts the pitch should be 1 mm.

    Click image for larger version. 

Name:	pitch.PNG 
Views:	9 
Size:	32.0 KB 
ID:	88661

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •