The cut path at the top of the board is to close to the edge. The path would cut down into the brass roller and it is telling you it will not cut that. To have tabs automatically always use the cut path tool. Pierced only pushes the pattern to the bottom of the board and you need to draw in manual lines for tabs and then use the add tabs tool.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Thanks that solved my issues was able to screw on another 3/4 x 3/4 board and make my cuts with an issue.