I'm looking for a little help from the brain trust here.
I'm trying to carve/cut a project in 1/2 corian. I ran the whole project with 1/2 plywood and had no problems. The first attempt with the corian the 1/16 carving bit made 1 pass (almost) and it stopped and gave me a y axis stall Err05-0314. I tried again and the machine told me to clean my y rails. (smart machine) The carriage did seem to hang up a bit but after wiping down the rails and moving it by hand it seemed fine. Then It told me the front roller switch was hanging up. I knocked the rollers up a couple of times and that seemed fine. Now when I try I keep getting a tracking roller failed error, Err49-0331. The oring on the tracking roller seems to look ok so I'm stumped.
I know it sounds like I have a dirty machine but I always use it with dust collection. In fact I just, and I mean just changed from the Dust Deputy to Floyds Ring Neck Blues collector that I had on a parts machine that I bought years ago used. MUCH better draw, love it Floyd.
I'd appreciate any suggestions. Thanks