If you have your old board sensor, take a box cutter knife and carefully remove the side. You can then blow it out and it will work fine without the side cover. I've been carving for two or more years with both of my machines with the cover off.
If you have your old board sensor, take a box cutter knife and carefully remove the side. You can then blow it out and it will work fine without the side cover. I've been carving for two or more years with both of my machines with the cover off.
The new board senors do not have the clear cover over them any more. I think they proved to be more of an issue than a help.
Would you happen to have a set of rubber belts and possibly a scanning probe.
I am looking for a controller
Do you have an X-Drive Gear Train Plate Assembly?
Carveright is out if Traction belts, both old and new.
Anyone know where I can get some, even if they're the old sand paper version?
Checking to see if by chance you would still have a complete left side panel and crank assembly. Including the keyboard.
Richard
If it is a job to go to work, learn something new. Life is to short to waste it on something you don't love.
I would take a chuck and a motor casing, rubber or sand paper belts.
Looking for a controller for the c series