Page 2 of 2 FirstFirst 12
Results 11 to 18 of 18

Thread: Parts What do you need ???

  1. #11

    Default

    If you have your old board sensor, take a box cutter knife and carefully remove the side. You can then blow it out and it will work fine without the side cover. I've been carving for two or more years with both of my machines with the cover off.

  2. #12
    Join Date
    Dec 2014
    Location
    Kaukauna, Wisconsin
    Posts
    600

    Default

    The new board senors do not have the clear cover over them any more. I think they proved to be more of an issue than a help.

  3. Default

    Would you happen to have a set of rubber belts and possibly a scanning probe.

  4. #14

    Default

    I am looking for a controller

  5. Default

    Do you have an X-Drive Gear Train Plate Assembly?

  6. Default Traction Belts

    Carveright is out if Traction belts, both old and new.
    Anyone know where I can get some, even if they're the old sand paper version?

  7. #17
    Join Date
    Jun 2009
    Location
    South Central Michigan
    Posts
    104

    Default

    Checking to see if by chance you would still have a complete left side panel and crank assembly. Including the keyboard.
    Richard

    If it is a job to go to work, learn something new. Life is to short to waste it on something you don't love.

  8. #18

    Default

    I would take a chuck and a motor casing, rubber or sand paper belts.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •