Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: Parts What do you need ???

  1. #11

    Default

    If you have your old board sensor, take a box cutter knife and carefully remove the side. You can then blow it out and it will work fine without the side cover. I've been carving for two or more years with both of my machines with the cover off.

  2. #12
    Join Date
    Dec 2014
    Location
    Kaukauna, Wisconsin
    Posts
    532

    Default

    The new board senors do not have the clear cover over them any more. I think they proved to be more of an issue than a help.

  3. Default

    Would you happen to have a set of rubber belts and possibly a scanning probe.

  4. #14

    Default

    I am looking for a controller

  5. Default

    Do you have an X-Drive Gear Train Plate Assembly?

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •