having trouble getting my importer to bring a file in getting corrupt file error , am about 99.9 percent sure the file is ok. I can open it in the 3D viewer and it is there. just cannot bring it in and carve it. any one have any ideas??
having trouble getting my importer to bring a file in getting corrupt file error , am about 99.9 percent sure the file is ok. I can open it in the 3D viewer and it is there. just cannot bring it in and carve it. any one have any ideas??
What size is the file? Have you tried the instructions from the Meshlab post?
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!