OK, this is driving me crazy. If someone could help me out, I would greatly appreciate it. Please do not just fix it for me because I need to make several of these with different dimension. Instructions would be greatly appreciated.
If you look at my mpc file, I have an extension I want to be at a 17-degree angle (93⁰ and 107⁰ respectfully) from the box on the left. I can change the angle to the preferred angle but then it moves the line that is attached to the extension line – not just the extension line. (Snap is off.) Yes, it does change the angle but now it has moved the wrong leg. It also changes the length of the line attached to the other end of the wrong leg that moved. Now I tried to change the length of the changed line back to the original length. But that moved the far line it was attached to making the left box out of square. Once I obtain the right angles, I would like to join the right end of the two extension lines to be able to create a cut path. Please tell me how to correct this project. I have put a circle around the angles referred to. I wouldn’t care if I have to start over if that accomplishes the correct results. All suggestions would be appreciated.
Angle help
Reply With Quote