Results 1 to 4 of 4

Thread: Had an error when I flipped my board

  1. Default Had an error when I flipped my board

    Hi All,

    I was in the middle of a carve, the back side completed, I was flipping the project board went to lower had error message front roller error, so i had to figure out what to do, finally got the error cleared, went to put project board to where I left off, however it is making me start all over? Isn't there a way I can get back to the side that I need to carve? I am really trying to learn this, getting a little better bur still need help. Thanks you in advance for any help you can send my way.

    Thank you
    Loriblackdog

  2. #2
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    As instructed over the phone, remove the back of the project from your .mpc file and re-upload the front only with a new name for the project.
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  3. Default

    Thank you so much, and I have made note of this so it won't happen again.

  4. #4
    Join Date
    Oct 2009
    Location
    Ohio
    Posts
    1,691

    Default

    If you have a 2 sided carve it will always cut the back side first. Just something to keep in mind Lori.
    CarverJerry

    ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •