What's wrong when all the bits I put into my machine to start a carve, come back saying "bit does not measure properly" ? It was asking for a 1/8" cutting bit, I put it in, rejected it. I put in the 1/8 carving bit, it didn't like that either. I tried both cutting & carving 1/16" bits, rejected both of them too. I have a 3/16" carving, it didn't like that one either. The only one I didn't try was the long 1/8 carving.

What's going on? What happens when I hit #2 and tell it to carry on?

Did I have a wrong bit in the machine at some point and it remembers that measurement? And wants to see it again?

Cutting is a sharp flat nose, and carving is a curved/angled point, right??