Hi everyone, I have a 2nd C machine I thought I'd keep as a parts machine but now would like to get it up and going again instead.

The problem with it is while it measures the boards fine & runs through the bit setup fine, it goes to run the project but won't turn on the cut motor. The cut motor is fine and I have hooked it up directly to plug in the wall and turned it on just to check it. It will not turn on from the key pad either.

My thought is that I need a new controller but at $375 I'd like a few other opinions. https://store.carvewright.com/produc...cat=254&page=1

Thanks