Results 1 to 3 of 3

Thread: Sleds

  1. #1

    Default Sleds

    Looking for some guidance *again*. I will be carving (two sided) the front of a wine box which is .250" thick and my sled is .5". All but my lettering is set to .065", so I should be ok there, I think. My question is, what do I set designer at and when the CW asks for thickness, what do I input? Thank you in advance.

  2. #2
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,349

    Default

    Input the size of the material on your sled. Do not include the size of your sled. It will give you a warning that the material is too thin, but you can hit continue, since you know you will have a board under it to go to the needed .5".
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  3. #3

    Default

    Thank you very much.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •