Hi. How can I make a verticle sign instead of a horizontal one? I want to make a Welcome sign that is up and down like this:
W
E
L
C
O
M
E
Thanks!
Hi. How can I make a verticle sign instead of a horizontal one? I want to make a Welcome sign that is up and down like this:
W
E
L
C
O
M
E
Thanks!
Linda
Set the line spacing in the middle box on the right in the text tool setup and press the enter key after typing each letter. When the text is placed on the board, rotate it 90°. In the example, the text spacing is set to 12 and placed in a carve region. It is also set as raster to make it 3D, and has a medium draft applied.
Last edited by SteveNelson46; 09-08-2019 at 12:30 PM.
Steve
Thank you! That makes complete sense!!!