Results 1 to 2 of 2

Thread: Jogging to Position

  1. #1
    Join Date
    Jun 2006
    Location
    Kansas
    Posts
    264

    Default Jogging to Position

    I have a 3'-6" long board but the caving is not in the center of the board so I can't use center pattern when carving.

    I have never used jog to position before and its asking for edge, corner or center, I think.

    What is the best way to find where I need to start the pattern in the Designer?
    I do know the feather part of the pattern is about 12" from the one end.

    Then I am assuming I just mark that spot on the wood and then jog to the position when it ask?

    Edit: I guess one of my concerns is not knowing what I am jogging to, I don't want the machine to start carving on the edge of the board if what I think is "corner" (or edge) is not what the machine thinks.
    Another Edit: Since my board in Designer is actual size, and the pattern is located appropriately in the software, could I just use the Corner option since it sounds like it will locate it from the start end of the board which is what I want?

    Thanks,
    Aaron

  2. #2
    Join Date
    Jun 2013
    Location
    Southeast Idaho
    Posts
    631

    Default

    Hi Aaron,

    Here is a good thread on positioning
    https://forum.carvewright.com/showth...rd-Positioning

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •