Results 1 to 6 of 6

Thread: Machine stuck in "Scan Area" mode.

  1. #1
    Join Date
    Nov 2008
    Location
    I live in Oxnard, CA.
    Posts
    22

    Default Machine stuck in "Scan Area" mode.

    When I turn my machine on the Menu Display goes to "Accessory Menu" 1) Scan Area. I do not know why and I cannot get out of that status to go to "Projects". In fact the only place I can go is "Options" but, nowhere else. I have rebooted. no help. formatted the card and reinstalled the firmware. no help.
    Apparently there is memory in the machine that holds the machine in that "Accessory Menu" mode. Anybody know how to get unstuck from this?

  2. #2
    Join Date
    Sep 2007
    Location
    Northern Colorado
    Posts
    7,655

    Default

    RingNeckBlues
    My patterns on the Depot
    DC-INSERT It Just Sucks!

    Proven to out perform all others!
    Buy CarveWright
    Colorado FaceBook Users Group


    All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.

  3. #3
    Join Date
    Nov 2008
    Location
    I live in Oxnard, CA.
    Posts
    22

    Default

    Thanks very much for the help! I still do not know how I got to the place I was in the menu.

  4. #4
    Join Date
    Sep 2007
    Location
    Northern Colorado
    Posts
    7,655

    Default

    Glad you got it corrected. Hard to say why it got reset.
    RingNeckBlues
    My patterns on the Depot
    DC-INSERT It Just Sucks!

    Proven to out perform all others!
    Buy CarveWright
    Colorado FaceBook Users Group


    All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.

  5. #5
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,895

    Default

    That Error came up when we changed from the 18 pin FFC Cable to the 14 pin Cable and changed the circuit board on both ends.
    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


  6. #6
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,338

    Default

    FYI for those that might find themselves stuck in the Scan mode - press 0-5-3 on the keypad.
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •