Results 1 to 3 of 3

Thread: Carving painted dark

  1. #1

    Default Carving painted dark


    0 Not allowed!
    My carving piece is painted dark and I’m getting the “check sensor” message. I read somewhere to put a strip of masking tape on the piece- exactly where do you put the tape? And how much? Thanks

  2. #2
    Join Date
    Dec 2017
    Location
    Tega Cay, SC
    Posts
    13

    Default


    0 Not allowed!
    Put the tape where the board sensor will measure your board. Board sensor is located under the truck (below the bit collect).

  3. #3
    Join Date
    Dec 2014
    Location
    Kaukauna, Wisconsin
    Posts
    464

    Default


    0 Not allowed!
    Put the tape in a T shape. One across where the sensor measures width then again where the sensor looks for the the edge of board.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •