Results 1 to 3 of 3

Thread: Carving painted dark

  1. #1

    Default Carving painted dark

    My carving piece is painted dark and I’m getting the “check sensor” message. I read somewhere to put a strip of masking tape on the piece- exactly where do you put the tape? And how much? Thanks

  2. #2
    Join Date
    Dec 2017
    Location
    Tega Cay, SC
    Posts
    13

    Default

    Put the tape where the board sensor will measure your board. Board sensor is located under the truck (below the bit collect).

  3. #3
    Join Date
    Dec 2014
    Location
    Kaukauna, Wisconsin
    Posts
    767

    Default

    Put the tape in a T shape. One across where the sensor measures width then again where the sensor looks for the the edge of board.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •