Started a project and the moment I selected the project the Z Axis stall appeared on the screen. The truck was in the center of the machine never moved, I did not hear any sound indicating a 'homing' attempt.
I first verified that I could easily move the truck in any direction without resistance. From responses previous posts I pulled of the cover on rear of the Z motor and verified everything was clean. Again from prior postings I replaced the FFC cable. Next I replaced the Z motor termination board, got the same error after all.
When I do a 0-7 and go to the sensor check for the Y & Z both readings changes when I move the truck .
The moment I select a project I get the stall message without hearing or seeing any attempt of movement. This is a back up machine with 30 hours on a new Controller.
Suggestions on the next step?
Thx, Rick H