Results 1 to 3 of 3

Thread: Edge Rout doesn’t make 90 degree corners

  1. #1

    Default Edge Rout doesn’t make 90 degree corners

    When I finish my carving - I use the Edge Rout icon to put a border around my carving- but it doesn’t make square corners- see my pics. What should I do ?
    Attached Thumbnails Attached Thumbnails 217CA93A-4B2C-4538-9A5A-38934FB087D0.jpeg   47A2A525-6B49-4A01-979F-0D55BC60F37E.jpeg  

  2. #2
    Join Date
    Sep 2007
    Northern Colorado


    That is do to the size and profile of the bit. I do all of my edge routing on the router table, not the CW.
    My patterns on the Depot
    DC-INSERT It Just Sucks!

    Proven to out perform all others!
    Buy CarveWright
    Colorado FaceBook Users Group

    All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.

  3. #3
    Join Date
    Nov 2008
    Vancouver Island


    The machine thinks that it is routing around the edge of the board (the virtual board in Designer). If your real board was the same size as the virtual board, the over routes would be in space! I think the edge route only works right if the virtual board and the real board are the same size.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts