I installed a new z-motor with no problem. Afterwards I did 4 or 5 new cutouts in a sled, like I’ve always done with no problems. Now all of a sudden it measures the board, it asks the general questions, then asks what bit with no problems. It then goes through the finding bit motion but after it fines the bit on the plate the z truck comes to the keypad side goes up and down a few times then goes back to the other side of the sled, drops right on the edge of the board or hits the edge of the board with the bit a few times and stalls out with the E06-0324 code. I’ve checked all my connections,including under the machine, made sure my z and y axis move freely, tried different outlets, different bits, different flex shaft. I’m at a loss on where to go from here. Any help would be appreciated. Thank you.


Sent from my iPhone using Tapatalk