Originally Posted by
PghDrake
Thanks for the response, Mugsowner! I'm not sure what "H F" is - another site I guess?
I was using a very hard walnut for this, and the bit is brand new but for one other carve that I posted in another thread. The depth was definitely part of the problem, I'm sure.
Good point on the carve, I wasn't thinking about it being an angled bit and that digging into the wall. I'll try to taper that in the future.
Thanks again!
-Don
I imagine he means Harbor Freight.
Mike
All Gave Some,
Some Gave All.
My computer configuration and software used:
Gigabyte GA-990XA-UD3 Motherboard, AMD FX 6-core Processor Black Edition, 32 Gig DDR 3 Ram, Gigabyte HD 6450 Video Card with 1 Gig DDR 3 ram, Windows 10
Designer 2.007, Designer 3.102, Pattern Editor, Centerline, Conforming Vectors, 2d Tools, 3d Tools, DXF Importer, STL Importer and Rotary Jig.