I have had my system for 8-10 years and still use the original basic software and wanted to try a lithopane. I created the jig and imported the test photo and when the "job" ran the error came up that the bit depth does not match......I then try option 7 to determine if the system could measure the thickness and got a "E06-0313 error.......z axis stall.

I then ran another small carving job (no lexan) that used the 1/16" carving bit and it worked fine.

For "grins" I took the jig and turned it over so that the lexan was now on the bottom and "hidden" and there was no error..........I then turn the jig back upright and "flipped" the lexan to reveal the remaining paper covered side and again there was no error........in both cases I "stopped" the project prior to actual material cutting.

It does not seem reasonable that one should have to leave the paper on the lexan to cut the project, but that is what this seems to be pointing to.

Any help/insights are appreciated.