Results 1 to 3 of 3

Thread: Understanding the Power Supply

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,984

    Default Understanding the Power Supply

    I found an interesting video of the troubleshooting of a power supply very similar to the CW. This power supply runs on 220 Volts AC because of his country location.

    He stresses that working on this power supply can be very dangerous as is OUR power supply running on line voltage of 115 volts AC.

    We have seen LHR has moved to an enclosed power supply for a much safer machine.

    Primarily we have only seen the L2 Coil snap off and if you look close to his schematic and the picture I posted you can see the L2 Coil in the circuit upper edge on the 5 volt line.

    This is just for the curious about how power supplies work.

    AL

    https://www.youtube.com/watch?v=hHMDFwgQnqk
    Attached Thumbnails Attached Thumbnails PS.png  
    Last edited by Digitalwoodshop; 02-06-2019 at 08:17 PM.
    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •