My machine had been in storage for a couple years. I finally have new workshop set up and did a small shell carve a month or so ago. Carved with no issue I started a new carve last night and have a few things happen. It started the carve and went about 1 inch into the carve and stopped it gave me a E05-0314 error code i tested cut motor would not turn sat for a while and then started when i tried it again. I reset the carve and it started then stopped again and this time gave me a E06-0314 error code and now the cut motor will not run i have not tried it today.

The only different is i added the sawdust extractor and changed the cover to a short version cover. I had the latest updates and mods done a couple years ago. Also with the new chuck does the bit slide all the way in so it is shoulder to shoulder or is there a space between check and bit neck
Any wisdom anyone can share for me please