What is happening
I can not figure out what is going on. The carve started out OK, but at 20% the bit started taking a gradual plunge and finally ended with an X error.
Can't find anything obviously wrong and just did the 750 hr maintenance about 20 hrs ago.
Any suggestions would be appreciated and Happy New Year to all fellow carvers.
Mike
All Gave Some,
Some Gave All.
My computer configuration and software used:
Gigabyte GA-990XA-UD3 Motherboard, AMD FX 6-core Processor Black Edition, 32 Gig DDR 3 Ram, Gigabyte HD 6450 Video Card with 1 Gig DDR 3 ram, Windows 10
Designer 2.007, Designer 3.102, Pattern Editor, Centerline, Conforming Vectors, 2d Tools, 3d Tools, DXF Importer, STL Importer and Rotary Jig.