Results 1 to 2 of 2

Thread: background lines

  1. 12-09-2018 #1
    gman
    gman is offline Junior Member
    Join Date
    Nov 2007
    Posts
    137

    Default background lines

    I have an older AL model that was recently overhauled at Carvewright. Lately it has been having an issue with lines in the carve region but not on the pattern that I have placed in said region. The pattern figure comes through very well, no lines. I will attempt to add a picture. Any thoughts?No luck on the picture, but the lines are about 1/16 wide and are vertical and randomly spaced maybe 1/8" apart and very shallow but obvious.
    Reply With Quote Reply With Quote
  2. 12-10-2018 #2
    Dale
    Dale is offline Member
    Join Date
    Dec 2010
    Location
    Coeur D'Alene Idaho
    Posts
    691

    Default

    I would check the Y and Z bearings especially the Y. It could be bad bearings or just a case of the bearings need adjusting. It could also be the little bearings in the Y gearbox and worst case the shaft is worn. Do a search for Y gearbox bearings and there is lots of info.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules