Whenever I do a cutout, like a plaque, the edges are ragged. It looks like the edge of a coin. Is this normal, or do I need to adjust something?
Thanks for any insight.
Whenever I do a cutout, like a plaque, the edges are ragged. It looks like the edge of a coin. Is this normal, or do I need to adjust something?
Thanks for any insight.
A picture would be helpful! In Designer when you zoom in on the cut path how does that look?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Sorry, I am not seeing a cut out (Cut Path) in these photos.
In your original question, I took your term "cutout" to mean Cut Path - is that correct? It is not "normal" to have ragged edges using Cut Path, but it can happen depending upon how you generated the vector for the Cut Path. For example, if you used Outline Pattern on a ragged pattern, it will result in a ragged cut. It would help if you posted a photo of your ragged cutout and the mpc for that project.
See if clicking on FLOOR FEATHER helps it any. You should be able to tell in the software.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
they used to have update on software like on 187 or the 2 and now the 3 nothing to make it better hope you get what I am saying
Henry
Every one has a photographic memory. Some just don't have film.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
How old is your bit? It looks like your cross cuts are good, but ripping is giving you issues. The grain of wood is much weaker when ripping due to the slack like appearance, which allows the bit to compress the grain fibers and move about easier. Harder woods hold up better as the grain does not compress as easy. Your using pine which tends to compress very easy, giving the fuzzier unclean look. A sharp bit is would be the answer here to allow it to cut with less resistances and vibration making a better cut.