X-drive conveyor stationary tube bearing

[badger2424]

Rubber Belt wasn’t tracking straight took it off an found I’ve got both bearings needed to be replaced on the in feed side of the stationary belt conveyor tube. LHR doesn’t sell these an was wondering if anyone knew exact size and a place to order from. Thx for your help.

[fwharris]

Do you have a part number? I could not find anything in the exploded parts view.

[Mugsowner]

The only real differences I see is the OD of the bearings of which the 688rs bearing that is out there is the smaller of the two. Not sure if you know anyone with a lathe, this could be remedied fairly easy with a sleeve, and your running. The other option out there is if someone is parting a machine. The problem there is they normally sell the whole unit as LHR does.

[badger2424]

Thanks for your help, I will keep looking.

[Mugsowner]

Do you have a way to measure the bearing? Would need OD. ID. and width to cross over. Do you see any numbers on the old bearings at all?

[Mugsowner]

Another issue I'm having is that LHR went outside OEM bearings to create their machines. For what they are getting for these bearings I would buy them and compare. Like I stated before just get sleeves made and life is good again.

[henry1]

Rubber Belt wasn’t tracking straight took it off an found I’ve got both bearings needed to be replaced on the in feed side of the stationary belt conveyor tube. LHR doesn’t sell these an was wondering if anyone knew exact size and a place to order from. Thx for your help.

You have a private message and go from there

[badger2424]

Bearing has no numbers but it's 3/4" tall, 1/4" wide with 5/16 diameter hole

[badger2424]

Or 19.5mmx6.92mm with 8mm diameter hole

[fwharris]

Do you have a picture of the part and where it is on the machine?