Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Head movement

  1. Default


    0 Not allowed!
    Its not the cover switch. That would give an error asking to close the cover. I have seen that message when accidentally leaving the cover up after loading the board or changing a tool. The cover is down but the cut motor just won't come on.
    Bob Campbell
    VIT Jr/Sr High School
    Table Grove, Illinois

  2. #12
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,811

    Default


    0 Not allowed!
    The LEFT cover switch talks to the Computer and tells it when the cover is open. The RIGHT switch is a safety switch for the cut motor and is in the path of the return wire of the cut motor. The computer does not know if the right switch is not working. The cut motor will not start with the right switch open.

    So in review the black wire from the X termination board goes to the black wire of the cut motor.
    The white wire from the cut motor goes THROUGH either wire of the Right side Safety Switch and to the X Termination Board white wire.
    Last edited by Digitalwoodshop; 1 Week Ago at 09:39 AM.
    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •