RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Glad the FFC Cable fixed it... Very hard to detect when they break as it is intermittent. I should make a tester for the cable with LED's... The hard part is buying the connector...
Yes, both the X, Y, and Z Motors have a Encoder Disk on the back. Here is a Y Encoder with dust in it....
Some pictures of the encoder and the cut motor brushes.
The Cut Motor Brushes and the "Y" Gearbox two 685ZZ Bearings should be replaced at 250 cut hours.
Good Job !!!!!
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com